Modular and easy to extend
Enersine ESD34 is designed in standard 19” rack
mounting and wall mounting configuration.
Enersine ESD34 is composed of one Control Module plus
several Power Modules.
Close/Open Loop Control
The CT is allowed to install at source or load side for
measure the harmonic current from the load. When CT
install at source side, the close loop control method is
used for best accuracy of harmonic current compensation.
Power Factor Correction
Enersine ESD34 not only compensate harmonic current but
also the reactive power. Enersine ESD34 is able to
correct for either a leading or lagging power factor.
Flexible up-grading/redundancy
In the event if the real value of the ILh is higher
than the estimated one, or the ILh increase due to
additional loads being added, there is no overload risk
on the existing Enersine ESD34 which have been selected.
Enersine ESD34 has current limit capability up to its
full rating, thus it will not shut down or malfunction
but will continue to operate in full compensating mode.
Additional Enersine ESD34 can be added in parallel on
site later to meet the increment of the ILh vaue.
The maximum parallel operation configuration is 8
control modules and different capacity can be operated
in parallel.
User-Friendly control panel
Enersine ESD34 is equipped with a user friendly control
panel. It is simple to turn the unit on or off and
features buzzer silence and system status.
The optional graphic LCD panel with special blue back
light offers access to all parameters, waveforms, &
spectrum for management of both Enersine ESD34 and
system power quality.
Communication Capability
Enersine ESD34 provides 2 communication slots for
install below communication cards.
● Standard RS232/USB Card
● Optional RS422/RS485 Card
● Optional Ethernet Card
Optional Monitoring Software
Enersine ESD34 provides optional monitoring software
ESD-Link34 for remote monitor and control. ESD-Link34
has below functions:
● Real Time Monitoring
● Download the Parameter, Waveform, Spectrum and Event
logs.
● Recorder for the Parameter
● Dry Contact programming
● Monitor up to 255 Units.
|
